How to Become a Computer Numerically Controlled Tool Programmers in Iowa
Computer Numerically Controlled Tool Programmers in Iowa earn a median salary of $56,660/year, which is 14% below the national average. Iowa has a state income tax of ~4.9%. After taxes and rent, a computer numerically controlled tool programmers takes home approximately $2,318/month. Most positions require High school diploma or equivalent.
What a computer numerically controlled tool programmers can afford in Iowa
Becoming a computer numerically controlled tool programmers in Iowa
Meet education requirements
Computer Numerically Controlled Tool Programmers positions in Iowa typically require High school diploma or equivalent. Programs are available at colleges and training institutions across Iowa. Research accredited programs in your area.
Gain required experience
Many computer numerically controlled tool programmers positions in Iowa require hands-on experience through internships, apprenticeships, or entry-level roles. Look for training programs and mentorship opportunities in your metro area.
Obtain Iowa licensure or certification
Iowa may require specific licensing or professional certification for computer numerically controlled tool programmerss. Requirements vary by state — contact the Iowa Department of Labor or relevant licensing board for current requirements, exam schedules, and application procedures.
Find positions in Iowa
Iowa employs 700 computer numerically controlled tool programmers. The highest concentrations are in Des Moines-West Des Moines and Cedar Rapids.
Computer Numerically Controlled Tool Programmers salary by metro area in Iowa
| Metro area | Median | Hourly | Employment |
|---|---|---|---|
| Des Moines-West Des Moines | $66K | $31.53/hr | 80 |
| Cedar Rapids | $64K | $30.85/hr | 50 |
| Waterloo-Cedar Falls | $58K | $27.67/hr | 80 |
| Dubuque | $53K | $25.51/hr | 70 |
| Davenport-Moline-Rock Island | $45K | $21.41/hr | 80 |
Computer Numerically Controlled Tool Programmers salary range in Iowa
Computer Numerically Controlled Tool Programmers careers in other states
Frequently asked questions
How much does a computer numerically controlled tool programmers make in Iowa?▼
The median computer numerically controlled tool programmers salary in Iowa is $56,660 per year ($27.24/hr). This is 14% below the national median of $65,670. Salaries range from $37,890 to $75,140.
What are the requirements to become a computer numerically controlled tool programmers in Iowa?▼
Computer Numerically Controlled Tool Programmers positions in Iowa typically require High school diploma or equivalent. Iowa may have specific licensing or certification requirements. Check with the Iowa licensing board or department of labor for current requirements.
Can a computer numerically controlled tool programmers afford to live in Iowa?▼
At the median salary of $56,660, a computer numerically controlled tool programmers in Iowa would take home approximately $3,730/month after taxes. With median 2-bedroom rent at $1,412/month, that's 37.9% of take-home pay going to housing. This exceeds the recommended 30% guideline.
What are the best cities for computer numerically controlled tool programmers in Iowa?▼
The highest paying metro areas for computer numerically controlled tool programmers in Iowa are Des Moines-West Des Moines ($65,580), Cedar Rapids ($64,170), Waterloo-Cedar Falls ($57,560). However, cost of living varies significantly between metros — a higher salary may not mean more purchasing power.
Does Iowa have state income tax for computer numerically controlled tool programmers?▼
Yes, Iowa has a state income tax rate of approximately 4.9%. On a $56,660 salary, this means roughly $2,804/year in state income tax. Use our take-home pay calculator for a detailed breakdown.